How to Clean a Double Tub Washer

Remove the rear cover, lift the outer and inner covers of the dehydration tank, take out the plastic pressure plate from the inner dehydration tank, remove the fastening screws between the inner dehydration tank and the flange of the dehydration shaft, and separate the inner tank and the flange with both hands. Slightly tilt the outer ring of the dehydration inner tub and lift it up slowly, then take out the dehydration shaft locking nut and tightening screw of the dehydration inner tub to loosen the coupling, pull out the dehydration tub from the dehydration outer tub, turn the washing machine upside down, and plug it with a towel. Put it into the center hole of the connecting bracket, and pour boiling water on the towel. After the connecting bracket is heated, break open the eight claw hooks, take out the water seal capsule and the connecting bracket, remove the rear cover, and untie the binding wire of the connecting wire to make the car Separate the lever from the brake plate, lift the outer cover of the dehydration bucket to the highest point, and press the brake pressure plate downward from the middle of the number slot of the conjoined bucket. Put the washing machine down, take out the dehydration motor, loosen the fastening screws of the upper brackets of the three vibration damping springs, take out the three vibration damping spring bracket assemblies nut and remove the coupling. Remove the fastening screws of the upper end cover of the brake pad and the dehydration motor, and then remove the brake pad assembly. Use a flat-blade screwdriver to push up the brake pad on the lower brake arm to separate the brake pad from the brake arm. Remove the brake pad, and then remove the brake pad from the brake arm. Remove the brake spring and brake wire from the brake pads.

https://www.wxrisen.com/